micrologic 5.0 trip unitmicrologic 5.0e user manual
micrologic 6.0a trip unit manual
micrologic 2.0 trip unit manual
micrologic trip unit manual
micrologic 5.0x manual
User manual. We do more with electricity. Setting the Micrologic 2.0 A control unit button for fault-trip reset and battery test.
The Micrologic 1 and 2 trip units are described in the Compact NSX circuit breakers – User manual. Micrologic 2.2 100 A trip unit.
The contactor can be closed again automatically or manually depending on the setting of the SDTAM Module (see the bulletin shipped with the circuit breaker for
Identify the trip unit installed on the circuit breaker by using the four characters on ComPact NSXMicroLogic 5/6/7 Electronic Trip Units – User Guide.This documentation is not intended as a substitute for and is not to be used for determining suitability or reliability of these products for specific user.
The procedure for closing the circuit breaker following a fault trip is presented in the circuit breaker user manual. Resetting the fault indications. Determine
The Micrologic 2.0A trip unit provides basic IEC (LS0) protection and a built-in ammeter. A. Trip unit name. B. Alphanumeric display.
Micrologic trip units can communicate with other devices if the optional. Circuit Breaker Communication Module (BCM) is installed. For information
Press the TEST button. The circuit breaker should trip. Refer to the manual that comes with the test kits. Tests.